Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL REAR AXLE HUB BOLT


F052137


  1. for 2WD:

    1. Install a new deflector gasket and deflector onto the rear axle shaft.

      HINT:
      Make sure that the deflector and deflector gasket are installed in the correct direction shown in the illustration.



    2. F052138
    3. Install the 5 bolts through the axle hub.

    4. Install a washer plate, as shown in the illustration, through the hub bolt, and install the hub bolt by tightening the hub nut.



    G020977
  1. for 4WD and Pre-Runner:

    1. Install a new deflector gasket and deflector onto the rear axle shaft.

      HINT:
      Align the 2 notches.



    2. G020973
    3. Install the 6 bolts through the axle hub.

    4. Install the washer plate, as shown in the illustration, through the hub bolt, and install the hub bolt by tightening the hub nut.



2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


F052139
  1. Position the backing plate on the rear axle bearing, and install the 4 parking brake plates onto the rear axle housing bolts using 2 socket wrenches and a press.

    HINT:
    The left and right side bearing assemblies have different part numbers and are not interchangeable side to side.



3. INSTALL REAR AXLE SHAFT WASHER
  1. Install the rear axle shaft plate washer onto the rear axle shaft.



4. INSTALL REAR AXLE BEARING RETAINER INNER
  1. Install a new rear axle bearing retainer inner onto the rear axle shaft.



5. INSTALL REAR AXLE SHAFT


F042778E01
  1. Using SST and a press, install the rear axle shaft onto the rear axle bearing.

    SST
    09521-25011  



6. INSTALL REAR AXLE SHAFT SNAP RING


F052133
  1. Using a snap ring expander, install a new snap ring.