Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH


E065594E11
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      1-2
      Switch pin free
      Below 1 Ω
      3-4
      Switch pin free
      10 kΩ or higher
      1-2
      Switch pin pushed in
      10 kΩ or higher
      3-4
      Switch pin pushed in
      Below 1 Ω

      If the result is not as specified, replace the stop light switch assembly.