HEADLIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL NO. 1 HEADLIGHT BULB |
Install the No. 1 headlight bulb.
![]() |
Lock the set spring in the direction indicated by the arrow in the illustration.
Install the socket cover.
| 2. INSTALL CLEARANCE LIGHT BULB |
Install the clearance light bulb into the clearance light socket.
![]() |
Turn the clearance light socket with the bulb in the direction indicated by the arrow in the illustration, to install them.
| 3. INSTALL FRONT TURN SIGNAL LIGHT BULB |
Install the front turn signal light bulb into the front turn signal light socket.
![]() |
Turn the front turn signal light socket with the bulb in the direction indicated by the arrow in the illustration, to install them.
| 4. INSTALL HEADLIGHT ASSEMBLY |
Connect the 3 connectors.
Engage the clamp and install the headlight assembly with the bolt and 2 screws.
| 5. INSTALL FRONT BUMPER COVER |
| 6. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT |
Prepare the vehicle:
| 7. PREPARATION FOR HEADLIGHT AIMING (for Using a Tester) |
Prepare the vehicle for headlight aim check.
Perform adjustment in accordance with the headlight tester instructions.
| 8. PREPARATION FOR HEADLIGHT AIMING (for Using a Screen) |
Prepare the vehicle according to the following conditions:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
Draw a vertical line down the center of screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Headlight height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the headlight bulb center marks of the low-beam headlights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) headlights):
Draw two vertical lines so that they intersect the H line at each center mark (aligned with the center of the low-beam headlight bulbs).
| 9. HEADLIGHT AIMING INSPECTION |
Cover the headlight or disconnect the connector of the headlight on the opposite side to prevent light from the headlight not being inspected from affecting headlight aiming inspection.
Start the engine.
Turn on the headlight and make sure that the cutoff line falls within the specified area, as shown in the illustration.

| 10. HEADLIGHT AIMING ADJUSTMENT |
![]() |
Adjust the aim vertically:
Adjust the headlight aim into the specified range by turning aiming screw A with a screwdriver.
Perform low-beam aim adjustment.
![]() |
Adjust the aim horizontally:
Adjust the headlight aim into the specified range by turning aiming screw B with a screwdriver.