HEADLIGHT DIMMER SWITCH > INSTALLATION |
| 1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY |
![]() |
Engage the 2 claws and install the headlight dimmer switch assembly as shown in the illustration.
![]() |
Install the headlight dimmer switch assembly with the clamp.
Connect the connector.
| 2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
Engage the claw and install the windshield wiper switch assembly.
Connect the 2 connectors.
| 3. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
Set the turn signal switch in neutral position.
Install the spiral cable sub-assembly with the 4 screws.
Connect the airbag connector and connector.
Install the steering column cover with the 3 screws.
| 4. INSTALL STEERING COLUMN UPPER COVER |
Engage the claw and then install the steering column cover upper.
| 5. INSTALL STEERING COLUMN LOWER COVER |
Engage the 2 claws.
Install the steering column cover lower with the 2 screws.
| 6. CENTER SPIRAL CABLE |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the negative battery terminal.
![]() |
Turn the cable counterclockwise by hand until it becomes harder to turn.
![]() |
Turn the cable clockwise about 2.5 turns to align the marks.
| 7. INSTALL STEERING WHEEL ASSEMBLY |
Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
Install the steering wheel assembly set nut.
| 8. INSPECT STEERING WHEEL CENTER POINT |
| 9. INSPECT HORN BUTTON ASSEMBLY |
| 10. INSTALL HORN BUTTON ASSEMBLY |
![]() |
| *1 | Locking Button |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Connect the 2 airbag connectors.
Connect the horn terminal.
Install the steering pad.
![]() |
Using T30 "TORX" socket wrench, tighten the 2 bolts.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT SRS WARNING LIGHT |
| 13. INSTALL NO. 3 STEERING WHEEL LOWER COVER |
Engage the claw and install the No. 3 lower steering wheel cover onto the steering wheel assembly.
| 14. INSTALL NO. 2 STEERING WHEEL LOWER COVER |
Engage the claw and install the No. 2 lower steering wheel cover onto the steering wheel assembly.