Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    E076075E02
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Dimmer Switch Assembly)

    Standard Resistance:
    Light Control Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    12-18-20
    OFF
    10 kΩ or higher
    12-18
    TAIL
    Below 1Ω
    12-18-20
    HEAD
    Below 1Ω
    Dimmer Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    11-12-17
    FLASH
    Below 1Ω
    12-16
    LOW BEAM
    Below 1Ω
    11-12
    HI BEAM
    Below 1Ω
    Turn Signal Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    12-13
    Right turn
    Below 1Ω
    12-13-15
    Neutral
    10 kΩ or higher
    12-15
    Left turn
    Below 1Ω

    If the result is not as specified, replace the headlight dimmer switch assembly.



2. INSPECT FRONT FOG LIGHT SWITCH


  1. Check the resistance.



      E076076E03
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Front Fog Light Switch)

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3-4
      OFF
      10 kΩ or higher
      3-4
      ON
      Below 1 Ω

      If the result is not as specified, replace the front fog light switch assembly.

  1. Check the illumination operation.

    1. Connect the battery positive (+) lead to terminal 1 and the battery negative (-) lead to terminal 2, then check that the illumination comes on.

      Standard:
      Illumination comes on.

      If the illumination does not come on, replace the bulb.