Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE NO. 2 STEERING WHEEL LOWER COVER


F052155E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the steering wheel cover lower No. 2.



5. REMOVE NO. 3 STEERING WHEEL LOWER COVER


F052156E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the No. 3 lower steering wheel cover.



6. REMOVE HORN BUTTON ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    E212025
  1. Using T30 "TORX" socket wrench, loosen the 2 bolts completely.

  1. Pull the steering pad toward rear.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    E212026E01
  1. Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.

  1. Disconnect the 2 airbag connectors.

    NOTICE:
    When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Locking button



    E212027
  1. Disconnect the horn terminal to remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


F044997E01
  1. Remove the steering wheel assembly set nut.

  1. Place matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN LOWER COVER


F051318E01
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the lower steering column cover.



9. REMOVE STEERING COLUMN UPPER COVER


F051319E01
  1. Disengage the claw and then remove the upper steering column cover.



10. REMOVE SPIRAL CABLE SUB-ASSEMBLY


F051337E01
  1. Disconnect the airbag connector and the connector from the spiral cable sub-assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag with harness.

  1. Disengage the 3 claws and remove the spiral cable sub-assembly.



11. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


E076073E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver wrapped with protective tape, disengage the claw and remove the windshield wiper switch assembly.

    NOTICE:
    The claw will break if pressed too hard.



12. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


I037768E04
  1. Disconnect the connector.

  1. Remove the headlight dimmer switch assembly as shown in the illustration.



    E068372E05
  1. Disengage the 2 claws and remove the headlight dimmer switch assembly.