Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WIPER ARM HEAD CAP


E076032E01
  1. Using a screwdriver wrapped with protective tape, remove the 2 front wiper arm head caps.



3. REMOVE FRONT WIPER ARM LH


E076033E01
  1. Operate the wiper, then stop the windshield wiper motor assembly at the automatic stop position.

  1. Remove the nut and front wiper arm LH.



4. REMOVE FRONT WIPER ARM RH

HINT:
Perform the same procedure as above on the opposite side.



5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


E076036E01
  1. Disengage the 2 claws and remove the front fender to cowl side seal LH.



6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:
Perform the same procedure as above on the opposite side.



7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


E076039E01
  1. Disengage the 2 clips.

  1. Disengage the 15 claws, then remove the cowl top ventilator louver sub-assembly.



8. REMOVE WINDSHIELD WIPER MOTOR AND LINK


E076058E01
  1. Disconnect the connector, then remove the 2 bolts.

  1. Slide the wiper link assembly to the passenger side seat side. Disengage the meshing of the rubber pin, then remove the windshield wiper motor & link assembly.



9. REMOVE FRONT WIPER MOTOR


E112544
  1. Using a screwdriver wrapped with protective tape, disengage the meshing of the 2 rods at the crank arm pivot of the windshield wiper motor assembly.



    E076043E01
  1. Using a "Torx" socket wrench (T30), remove the 2 screws and windshield wiper motor assembly.