Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER SWITCH

WIPER SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE STEERING COLUMN LOWER COVER


F051318E01
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the lower steering column cover.



3. REMOVE STEERING COLUMN UPPER COVER


F051319E01
  1. Disengage the claw and then remove the upper steering column cover.



4. REMOVE WIPER SWITCH


E076073E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver wrapped with protective tape, disengage the claw and remove the windshield wiper switch assembly.

    NOTICE:
    The claw will break if pressed too hard.