QUARTER WINDOW GLASS (for Access Cab) > REMOVAL |
| 1. REMOVE REAR ACCESS PANEL WEATHERSTRIP |
![]() |
Remove the access panel rear weatherstrip LH.
| 2. REMOVE LAP BELT OUTER ANCHOR COVER |
![]() |
Disengage the 3 claws and remove the lap belt outer anchor cover.
| 3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Remove the bolt and separate the outer front seat belt assembly LH (floor side).
![]() |
Using a screwdriver with its tip wrapped in protective tape, open the cover.
![]() |
Remove the screw, and then remove the access panel inside handle bezel LH.
![]() |
Remove the screw, and then remove the door pull handle.
![]() |
Remove the 10 clips.
Remove the rear door trim board sub-assembly by sliding it upward.
| 4. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
Apply protective tape to the outer circumference of the quarter window, as shown in the illustration.
From the interior, insert piano wires between the vehicle body and quarter window, as shown in the illustration.
When separating the quarter window from the vehicle, be careful not to damage the vehicle's paint or exterior/interior ornaments.
Cut through the adhesive by pulling the piano wire around the quarter window.