Home › ENGINE ยท 2TR-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between low and full marks on the oil level gage.
    If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.



2. INSPECT OIL PRESSURE


G038191E01
  1. Remove the 4 bolts, then remove the No. 1 engine under cover. (PRE RUNNER AND 4WD TYPE)

  1. Disconnect the oil pressure switch connector.

  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



    G038192E01
  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Inspect the oil pressure.
    Oil pressure 
    When Idling
    29 kPa (0.3 kgf*cm2, 4.2 psi) or more
    At 3,000 rpm
    160 to 490 kPa (1.6 to 5.3 kgf*cm2, 23 to 75 psi)

  1. Remove the oil pressure gauge.



    A085603E03
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch connector.

  1. Check for engine oil leakage.

  1. Install the engine under cover No. 1 with the 4 bolts. (PRE RUNNER AND 4WD TYPE)

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }