Home › ENGINE ยท 2TR-FE › LUBRICATION › OIL FILTER

OIL FILTER > INSTALLATION

for Preparation Click here



1. INSTALL OIL FILTER SUB-ASSEMBLY
  1. Remove any dirt or foreign objects from the contact surface of the engine side.

  1. Apply a light coat of engine oil to the O-ring of a new oil filter.

  1. Install the oil filter by hand until the O-ring comes into contact with the seat.

  1. Using SST, retighten it by 3/4 turn.

    SST
    09228-07501  

    1. Depending on the work space available, choose from the following:


      1. G038194E02
        If enough space is not available to use a torque wrench, tighten the oil filter an additional 3/4 turn by hand or use a standard wrench.
        Text in Illustration 
        *a
        3/4 Turn
      2. If enough space is available, use a torque wrench to tighten the oil filter.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }



2. ADD ENGINE OIL
  1. Fill with fresh engine oil.

    Standard engine oil:

    Oil grade
    Oil viscosity (SAE)
    ILSAC multigrade engine oil
    0W-20


    Standard capacity:

    Item
    Specified Condition
    Drain and refill with oil filter change
    5.8 liters (6.1 US qts, 5.1 Imp. qts)
    Drain and refill without oil filter change
    5.1 liters (5.4 US qts, 4.5 Imp. qts)
    Dry fill
    6.1 liters (6.4 US qts, 5.4 Imp. qts)



3. CHECK FOR ENGINE OIL LEAKAGE