BRAKE PEDAL > ON-VEHICLE INSPECTION |
| 1. INSPECT BRAKE PEDAL HEIGHT |
![]() |
Check the brake pedal height.
| Type | Pedal Height |
| Hydraulic brake booster | 158.6 to 168.6 mm (6.25 to 6.63 in.) |
| Vacuum brake booster, Automatic transmission | 159.8 to 169.8 mm (6.30 to 6.68 in.) |
| Vacuum brake booster, Manual transmission | 156.6 to 166.6 mm (6.17 to 6.55 in.) |
![]() |
Adjust the rod operating adapter length.
Remove the clip and clevis pin.
Loosen the clevis lock nut.
Adjust the rod operating adapter length by turning the pedal push rod clevis.
Tighten the clevis lock nut.
Install the clip and clevis pin.
| 2. INSPECT AND ADJUST STOP LIGHT SWITCH ASSEMBLY |
Disconnect the stop light switch connector from the stop light switch.
Turn the stop light switch counterclockwise, and remove the stop light switch.
![]() |
Insert the stop light switch until the body comes into contact with the cushion.
![]() |
Make a quarter turn clockwise to install the stop light switch.
Check the protrusion of the rod.
Connect the stop light switch connector to the stop light switch.
| 3. INSPECT PEDAL FREE PLAY |
![]() |
Stop the engine and depress the brake pedal several times until there is no more vacuum left in the booster.
Push in the pedal until the beginning of the resistance is felt. Measure the distance as shown.
| 4. INSPECT PEDAL RESERVE DISTANCE |
![]() |
Release the parking brake pedal.
With the engine running, depress the pedal and measure the pedal reserve distance as shown.