Home › BRAKE › BRAKE › FRONT BRAKE (for 4WD and Pre-Runner)

FRONT BRAKE (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE FRONT DISC BRAKE ANTI RATTLE WITH HOLE PIN


F043185
  1. Remove the 2 pin hold clips, then remove the 2 anti-rattle w/ hole pins from the disc brake cylinder.

  1. Remove the anti-rattle spring from the disc brake pad.



4. REMOVE DISC BRAKE PAD KIT FRONT
  1. Remove the 2 disc brake pads with anti-squeal shim from the disc brake cylinder.



5. REMOVE ANTI SQUEAL SHIM KIT FRONT
  1. Remove the 2 anti-squeal shims from each of the disc brake pads.



6. REMOVE DISC BRAKE CYLINDER ASSEMBLY


F043120
  1. Using a union nut wrench, disconnect the brake tube from the disc brake cylinder.

    HINT:
    Use a container to collect the brake fluid as it drains out.



    F043121
  1. Remove the 2 bolts and disc brake cylinder.



7. INSPECT DISC THICKNESS


F042680
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    28.0 mm (1.102 in.)

    Minimum thickness:
    26.0 mm (1.024 in.)



8. REMOVE FRONT DISC
  1. Make matchmarks on the disc and the axle hub.

  1. Remove the front disc.