Home › BRAKE › BRAKE › FRONT BRAKE (for 4WD and Pre-Runner)

FRONT BRAKE (for 4WD and Pre-Runner) > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


F043024
  1. Using a screwdriver, remove the 4 cylinder boots from the caliper.



2. REMOVE FRONT DISC BRAKE PISTON


F042676E01
  1. Prepare a wooden plate to hold the pistons.



    F042677
  1. Place the plate between the pistons and insert a pad into one side.

  1. Use compressed air and remove the pistons one side at a time from the cylinder.

    CAUTION:
    Do not place your fingers in front of the pistons when using compressed air.



3. REMOVE PISTON SEAL


F042678
  1. Using a screwdriver, remove the 4 piston seals from the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the disc brake cylinder.