FRONT BRAKE (for 4WD and Pre-Runner) > REASSEMBLY |
| 1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
Provisionally tighten the bleeder plug to the disc brake cylinder.
Install the bleeder plug cap onto the bleeder plug.
| 2. INSTALL PISTON SEAL |
![]() |
Apply lithium soap base glycol grease to 4 new piston seals.
Install the 4 piston seals onto the disc brake cylinder.
| 3. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply lithium soap base glycol grease to the 4 disc brake pistons and a new 4 cylinder boots.
Install the 4 disc brake pistons onto the disc brake cylinder.
| 4. INSTALL CYLINDER BOOT |
![]() |
Install the 4 cylinder boots onto the disc brake cylinder.
Install the 4 cylinder boot set rings.