Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > REASSEMBLY

for Preparation Click here



1. INSTALL REAR WHEEL CYLINDER CUP KIT


C179334E01
  1. Provisionally tighten the bleeder plug to the rear wheel brake cylinder, and install the bleeder plug cap.

  1. Apply lithium soap base glycol grease to 2 new cylinder cups and the 2 pistons.

  1. Install the cylinder cup onto each piston.

  1. Install the compression spring and 2 pistons onto the rear wheel brake cylinder.

  1. Install the 2 new wheel cylinder boots onto the rear wheel brake cylinder.



2. INSTALL FRONT OR UPPER REAR WHEEL BRAKE CYLINDER ASSEMBLY


F050546
  1. Install the rear wheel brake cylinder assembly with the 2 bolts.

    Torque:
    9.5 N*m{ 97 kgf*cm , 84 in.*lbf }

  1. Using a union nut wrench, connect the brake tube.

    Torque:
    without union nut wrench:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }
    with union nut wrench:
    14 N*m{ 145 kgf*cm , 10 ft.*lbf }

    HINT:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a fulcrum length of 22 mm (0.866 in.) (Click here).
    2. This torque value is effective when the union nut wrench is parallel to the torque wrench.



3. APPLY HIGH TEMPERATURE GREASE


C179335E01
  1. Apply high temperature grease to the shoe attached surface of the backing plate.



4. INSTALL REAR BRAKE SHOE


C179336E01
  1. Apply high temperature grease to the adjusting bolt.



    F050550
  1. Install the parking brake shoe lever LH and parking brake shoe strut set with the shoe return spring onto the rear brake shoe.



    F050544
  1. Using pliers, install the parking brake shoe strut set, parking brake reaction lever and parking brake shoe lever LH with 2 new C-washers.



    F042688
  1. Using needle-nose pliers, connect the parking brake cable No. 3 to the parking brake shoe lever LH.



    F050543E01
  1. Using SST, install the rear brake shoe, pin, shoe hold down spring and shoe hold down spring cup.

    SST
    09718-00010  



5. INSTALL FRONT BRAKE SHOE
  1. Install the automatic adjust lever LH, automatic adjust lever spring and parking brake shoe strut lower onto the front brake shoe.



    F050542E01
  1. Using SST, install the front brake shoe, pin, shoe hold down spring and shoe hold down spring cup.

    SST
    09718-00010  



    F042698
  1. Install the tension spring onto the front brake shoe and rear brake shoe.



    F050551
  1. Using needle-nose pliers, install the return spring.



    F050540E01
  1. Using SST, install the shoe return spring onto the front brake shoe.

    SST
    09921-00010  



6. INSPECT REAR DRUM BRAKE INSTALLATION


  1. Check that each part is installed properly.


    F050552E01



    F050553E01
  1. Measure the brake drum inside diameter and the diameter of the brake shoes. Check that difference between the diameters is the specified shoe clearance.

    Shoe clearance:
    0.5 mm (0.0197 in.)

    NOTICE:
    There should be no oil or grease adhering to the friction surfaces of the shoe lining and the drum.