BRAKE MASTER CYLINDER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN BRAKE FLUID |
| 3. REMOVE CLUTCH RESERVOIR TUBE (for Manual Transmission) |
![]() |
Disconnect the clutch reservoir tube from the reservoir.
| 4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Disconnect the brake fluid level warning switch connector.
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.
![]() |
Remove the 2 nuts, and then pull the brake master cylinder sub-assembly out of the brake booster.
Remove the O-ring from the brake master cylinder sub-assembly.