Home › BRAKE › PARKING BRAKE › PARKING BRAKE PEDAL (for Automatic Transmission)

PARKING BRAKE PEDAL (for Automatic Transmission) > INSTALLATION

for Preparation Click here



1. INSTALL PARKING PEDAL PAD


2. INSTALL PARKING BRAKE SWITCH ASSEMBLY
  1. Install the parking brake switch assembly with the screw.



3. INSTALL PARKING BRAKE PEDAL


F050701E01
  1. Install the parking brake control pedal assembly with the 3 nuts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the parking brake switch connector.



4. INSTALL PARKING BRAKE CABLE ASSEMBLY NO. 1


F050657E01
  1. Install the parking brake cable assembly No. 1 with the clip (labeled D), adjusting nut (labeled C) and lock nut (labeled B).

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Bend the claw (labeled A).



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

(Click here)


6. INSPECT PARKING BRAKE PEDAL TRAVEL
  1. Slowly depress the parking brake pedal to the fully applied position, and count the number of clicks.

    Parking brake pedal travel at 300 N (31 kgf, 67 lbf):
    7 to 10 clicks



7. ADJUST PARKING BRAKE PEDAL TRAVEL
  1. Confirm that the parking brake pedal is released.



    F050697E01
  1. Loosen the lock nut (labeled A) and turn the adjusting nut (labeled B) until the parking brake pedal travel is corrected to the specified value.

  1. Tighten the lock nut.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake pedal, check that the parking brake pedal indicator light comes on.