Home › STEERING › POWER STEERING › VANE PUMP (for 2TR-FE)

VANE PUMP (for 2TR-FE) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO. 1 (for 4WD and Pre-Runner)


3. REMOVE FAN AND GENERATOR V BELT


G038203E01
  1. Turning the hexagonal bolt on the V-ribbed belt tensioner clockwise, loosen and then remove the V belt.



4. DRAIN POWER STEERING FLUID


5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


F051262
  1. Disengage the clip and disconnect the return hose.



    F051263
  1. Remove the union bolt, then disconnect the pressure feed tube.

  1. Remove the gasket from the pressure feed tube.



6. REMOVE VANE PUMP


F051264
  1. Disconnect the oil pressure switch connector.



    F051265
  1. Remove the 2 bolts and vane pump assembly.