Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO. 1 (for 4WD and Pre-Runner)


3. REMOVE FAN & GENERATOR V BELT


A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.



4. DRAIN POWER STEERING FLUID


5. DISCONNECT OIL RESERVOIR TO PUMP HOSE NO. 1


F051257
  1. Disengage the clip and disconnect the oil reservoir to pump hose No. 1.



6. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


F051258
  1. Remove the union bolt, then disconnect the pressure feed tube.

  1. Remove the gasket from the pressure feed tube.



7. REMOVE VANE PUMP


F051259
  1. Disconnect the oil pressure switch connector.

  1. Remove the bolt and wire harness clamp bracket.



    F051260
  1. Remove the 2 bolts and vane pump assembly.