Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER

CLUTCH MASTER CYLINDER > REMOVAL

for Preparation Click here



1. DRAIN CLUTCH FLUID


2. DISCONNECT CLUTCH RESERVOIR TUBE


3. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


F050807E02
  1. Using a union nut wrench, disconnect the flexible hose tube.



4. REMOVE FRONT DOOR SCUFF PLATE LH


5. REMOVE COWL SIDE TRIM BOARD LH


6. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    B085780E01
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 clips and remove the lower No. 1 instrument panel finish panel.

  1. Disconnect the connectors.



7. SEPARATE DRIVER SIDE JUNCTION BLOCK


8. REMOVE CLUTCH PEDAL WITH CLUTCH MASTER CYLINDER
  1. Disconnect the clutch start switch connector.



    F050808
  1. Remove the 2 nuts, the bolt and the clutch pedal with clutch master cylinder.



9. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
  1. Disconnect the clutch reservoir tube.



    F050809E02
  1. Using a union nut wrench, disconnect the 2 way tube from the clutch master cylinder assembly.



    F050810
  1. Remove the nut and the clutch start switch from the clutch pedal support.



    F050811
  1. Remove the 2 bolts and the clutch master cylinder assembly.