CANISTER > INSTALLATION |
| 1. INSTALL CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY |
Install a new charcoal canister leak detection pump with the 3 bolts.
Connect the vacuum hose.
| 2. INSTALL CHARCOAL CANISTER ASSEMBLY |
Connect the fuel tank vent hose.
Align the fuel tank vent hose connector with the pipe, then push in the fuel tank vent connector until the retainer makes a "click" sound to connect the fuel tank vent hose to the charcoal canister.
Install the charcoal canister with the bolt and 2 nuts.
Connect the EVAP tube.
Connect the connector.
| 3. INSTALL NO. 2 CHARCOAL CANISTER FILTER |
Install the No. 2 charcoal canister filter with the nut.
Connect the breather hose to the charcoal canister.
Engage the clamp.
Connect the breather hose to the pipe.
Connect the EVAP pipe to the clamp.
Install the ABS wire harness clamp with the bolt.
| 4. INSTALL FUEL TANK ASSEMBLY |
Set the fuel tank assembly onto the mission jack.
Connect the fuel tank vent hose.
Align the fuel tank vent connector with the pipe, then push in the fuel tank vent connector until the retainer makes a "click" sound to connect the fuel tank vent hose to the fuel suction plate.
Connect the fuel pump connector.
Connect the fuel tank to filler pipe hose.
Install the fuel pump cover.
Install the 2 fuel tank bands.
Install the 2 fuel tank bands with the 2 pins and 2 clips.
Install the 2 fuel tank bands with the 2 bolts.
![]() |
Connect the fuel tank breather tube.
Align the fuel tube connector with the pipe, then push the fuel tube connector in until the retainer makes a "click" sound to connect the fuel tank vent breather tube.
Install the checker onto the pipe.
Tighten the clamp bolt.
| 5. CONNECT FUEL TANK MAIN TUBE AND FUEL TANK RETURN TUBE |
![]() |
Connect the fuel tank main tube and return tube.
Align the fuel tube connector with the pipe, then push the fuel tube connector in until the retainer makes a "click" sound to connect the fuel tank main tube and return tube.
Install the fuel pipe clamp.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK FOR FUEL LEAKAGE |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the tester ON.
Enter the following menus:
Select: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed / ON.
Check that there are no leakage in the fuel system.