CANISTER > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. DISCONNECT FUEL TANK MAIN TUBE AND FUEL TANK RETURN TUBE |
![]() |
Remove the fuel pipe clamp.
![]() |
Disconnect the fuel tank main tube and fuel tank return tube.
Pinch the retainer as illustrated, then pull the fuel tube connectors out of the pipes.
| 4. REMOVE FUEL TANK ASSEMBLY |
![]() |
Loosen the clamp bolt.
Disconnect the fuel breather tube.
Remove the checker of the fuel tube connector from the pipe.
Pinch the retainer of the fuel tube connector, then pull the tube connector out of the pipe.
Hold the fuel tank using the mission jack.
![]() |
Remove the 2 fuel tank bands.
Remove the 2 bolts.
Remove the 2 clips and 2 pins, then remove the 2 fuel tank bands.
Remove the fuel pump cover.
Slightly jack the fuel tank down and separate the fuel tank to filler pipe hose from the inlet pipe.
Disconnect the fuel pump connector.
Disconnect the fuel tank vent hose.
Pinch the retainer and pull the fuel tank vent hose connector out of the charcoal canister to disconnect the fuel tank vent hose from the charcoal canister.
Remove the fuel tank assembly.

| 5. REMOVE NO. 2 CHARCOAL CANISTER FILTER |
![]() |
Remove the bolt, then remove the ABS wire harness clamp from the charcoal canister.
![]() |
Release the EVAP pipe from the hose clamp.
Disconnect the breather hose from the pipe.
Disengage the hose clamp.
![]() |
Disconnect the breather hose from the charcoal canister.
![]() |
Remove the nut, then remove the No. 2 charcoal canister filter.
| 6. REMOVE CHARCOAL CANISTER ASSEMBLY |
![]() |
Disconnect the connector.
Disconnect the EVAP tube.
![]() |
Remove the bolt and 2 nuts, then remove the charcoal canister.
![]() |
Disconnect the fuel tank vent hose.
Pinch the retainer and pull the fuel tank vent hose connector out of the charcoal canister to disconnect the fuel tank vent hose from the charcoal canister.
| *a | Pinch |
| *b | Push |
| 7. REMOVE CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY |
Before removing the charcoal canister leak detection pump, clean the canister by blowing air on its outside to ensure that the canister is free of foreign matter.
![]() |
Disconnect the vacuum hose.
Remove the 3 bolts and charcoal canister leak detection pump.
![]() |
Check if the canister contains foreign matter such as mud or water.
Visually check that the inside of the canister is free of foreign matter.
Hold the canister upside down to make sure that the canister is free of foreign matter. If the canister contains foreign matter, replace the canister.