CLUTCH UNIT (for R155F) > REMOVAL |
| 1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY |
| 2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Remove the clutch release fork together with the clutch release bearing from the transmission assembly.
| 3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY |
Remove the clutch release bearing assembly from the clutch release fork.
| 4. REMOVE RELEASE FORK SUPPORT |
Remove the release fork support from the transaxle assembly.
| 5. REMOVE RELEASE BEARING HUB CLIP |
| 6. REMOVE CLUTCH RELEASE FORK BOOT |
| 7. REMOVE CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmark on the clutch cover assembly with the one on the flywheel sub-assembly.
Loosen each set bolt one turn at a time until the spring tension is released.
Remove the 6 bolts and clutch cover assembly.
| 8. REMOVE CLUTCH DISC ASSEMBLY |
| 9. REMOVE INPUT SHAFT BEARING |
![]() |
Remove the 4 bolts at diametrically opposite points.
Using SST, remove the pilot bearing.