Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for RA60)

CLUTCH UNIT (for RA60) > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH DISC ASSEMBLY


F050787
  1. Using vernier calipers, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)

    If necessary, replace the clutch disc assembly.

  1. Install the clutch disc assembly onto the transaxle assembly.

    NOTICE:
    Take care not to insert the clutch disc assembly in the wrong orientation.



    CL00373
  1. Using a dial indicator, check the clutch disc assembly runout.

    Minimum runout:
    1.0 mm (0.039 in.)

    If necessary, replace the clutch disc assembly.



2. INSPECT CLUTCH COVER ASSEMBLY


F050788E01
  1. Using vernier calipers, inspect the depth and width of wear of the diaphragm spring.

    Minimum:
    A (Depth): 0.5 mm (0.020 in.)
    B (Width): 6.0 mm (0.236 in.)

    If necessary, replace the clutch cover assembly.



3. INSPECT FLYWHEEL SUB-ASSEMBLY


F050789
  1. Using a dial indicator, inspect the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    If necessary, replace the flywheel sub-assembly.



4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


F050790
  1. Turn the release bearing by hand while applying force in the axial direction.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.
    If necessary, replace the release bearing assembly.