CLUTCH UNIT (for RA60F) > INSTALLATION |
| 1. INSTALL CLUTCH DISC ASSEMBLY |
![]() |
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
| 2. INSTALL CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.
| 3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() |
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
| 4. INSTALL RELEASE FORK SUPPORT |
Install the release fork support onto the transaxle assembly.
| 5. INSTALL RELEASE BEARING HUB CLIP |
| 6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Apply release hub grease to the release fork and release the bearing assembly contact surfaces, release fork and push rod contact surface and release fork pivot point.
| *1 | Release hub grease |
Install the release fork onto the release bearing assembly.
| 7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
Apply clutch spline grease to the input shaft spline.
Install the bearing onto the release fork, and then install them onto the transaxle assembly.
| 8. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |