OUTPUT SHAFT > DISASSEMBLY |
| 1. INSPECT 1ST GEAR THRUST CLEARANCE |
![]() |
Using a dial indicator measure the thrust clearance of the 1st gear.
| 2. INSPECT 2ND GEAR THRUST CLEARANCE |
![]() |
Using a dial indicator measure the thrust clearance of the 2nd gear.
| 3. INSPECT 3RD GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance of the 3rd gear.
| 4. INSPECT 1ST GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the 1st gear.
| 5. INSPECT 2ND GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the 2nd gear.
| 6. INSPECT 3RD GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the 3rd gear.
| 7. REMOVE 1ST GEAR |
![]() |
Using SST and a press, remove the 5th gear, output shaft center bearing, 1st gear thrust washer and 1st gear from the output shaft.
| 8. REMOVE NO. 1 SYNCHRONIZER RING |
![]() |
Remove synchronizer ring No. 1 (for the 1st gear) from the output shaft.
| 9. REMOVE 1ST GEAR THRUST WASHER PIN OR BALL |
![]() |
Remove the 1st gear thrust washer pin from the output shaft.
| 10. REMOVE 1ST GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 1st gear needle roller bearing from the output shaft.
| 11. REMOVE 1ST GEAR BEARING SPACER |
![]() |
Remove the 1st gear bearing spacer from the output shaft.
| 12. REMOVE BEARING SHAFT SNAP RING |
![]() |
Using 2 screwdrivers and a hammer, remove the bearing shaft snap ring from the output shaft.
| 13. REMOVE 2ND GEAR |
![]() |
Using SST and a press, remove the transmission clutch hub No. 1, reverse gear, synchronizer ring No. 1 and 2nd gear from the output shaft.
| 14. REMOVE 2ND GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 2nd gear needle roller bearing from the output shaft.
| 15. REMOVE REVERSE GEAR |
![]() |
Remove the reverse gear, 3 synchromesh shifting keys No. 1 and 3 synchromesh shifting key springs.
Use a shop rag to prevent the shifting key and the shifting spring from popping out.
| 16. REMOVE CLUTCH HUB SET SHAFT SNAP RING |
![]() |
Using snap ring pliers, remove the clutch hub set shaft snap ring from the output shaft.
| 17. REMOVE 3RD GEAR |
![]() |
Using SST and a press, remove the clutch hub No. 2 with the hub sleeve No. 2, synchronizer ring No. 2 and 3rd gear from the output shaft.
| 18. REMOVE 3RD GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 3rd gear needle roller bearing from the output shaft.
| 19. REMOVE NO. 2 TRANSMISSION HUB SLEEVE |
![]() |
Remove the transmission hub sleeve No. 2, 3 synchromesh shifting key springs and 3 synchromesh shifting keys No. 2 from the transmission clutch hub No. 2.