COUNTER GEAR > REASSEMBLY |
| 1. INSTALL COUNTER GEAR FRONT BEARING OR ROLLER |
![]() |
Using SST and a press, install the counter gear front bearing onto the counter gear.
| 2. INSTALL NO. 2 COUNTER GEAR FRONT BEARING SNAP RING |
![]() |
Select the correct counter gear front bearing No. 2 snap ring so that the clearance between the counter gear and No. 2 counter gear front bearing snap ring No. 2 is within the specified values. Using a brass bar and a hammer, install it onto the counter gear.
| Mark | Thickness mm (in.) |
| A | 2.05 to 2.10 (0.0807 to 0.0827) |
| B | 2.10 to 2.15 (0.0827 to 0.0846) |
| C | 2.15 to 2.20 (0.0846 to 0.0866) |
| D | 2.20 to 2.25 (0.0866 to 0.0886) |
| E | 2.25 to 2.30 (0.0886 to 0.0906) |
| F | 2.30 to 2.35 (0.0906 to 0.0925) |