COUNTER GEAR > INSPECTION |
| 1. INSPECT COUNTER GEAR |
![]() |
Using a dial indicator and 2 V-blocks, measure the shaft runout.
![]() |
Using a micrometer, measure the outer diameter of the input shaft journal surface.
| Part | Outer diameter mm (in.) |
| A | 34.002 to 34.015 (1.3387 to 1.3392) |
| B | 36.985 to 37.000 (1.4561 to 1.4567) |
| C | 47.985 to 48.000 (1.8892 to 1.8898) |
| D | 53.985 to 54.000 (2.1254 to 2.1260) |
| E | 34.002 to 34.015 (1.3387 to 1.3392) |
| Part | Outer diameter mm (in.) |
| A | 34.002 (1.3387) |
| B | 36.985 (1.4561) |
| C | 47.985 (1.8892) |
| D | 53.985 (2.1254) |
| E | 34.002 (1.3387) |
| 2. INSPECT COUNTERSHAFT REVERSE GEAR |
![]() |
Using cylinder gauge, measure the inside diameter of the reverse gear.
| 3. INSPECT COUNTERSHAFT GEAR 1ST SPEED |
![]() |
Using cylinder gauge, measure the inside diameter of the 1st gear.
| 4. INSPECT COUNTER SHAFT 2ND SPEED GEAR |
![]() |
Using cylinder gauge, measure the inside diameter of the 2nd gear.
| 5. INSPECT NO. 3 TRANSMISSION HUB SLEEVE |
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No. 3 groove (A) and the thickness of the claw part on the gear shift fork No. 4 (B), and calculate the clearance.
| 6. INSPECT NO. 1 TRANSMISSION HUB SLEEVE |
![]() |
Check the sliding condition between the transmission hub No. 1 and transmission hub sleeve No. 1.
Check that the spline gear teeth of the transmission hub sleeve No. 1 are not worn.
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No. 1 groove (A) and the thickness of the claw part on the gear shift fork No. 1 (B), and calculate the clearance.
| 7. INSPECT NO. 4 SYNCHRONIZER RING |
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and reverse gear.
![]() |
Coat the reverse gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the reverse gear cone. Check that the ring locks.
| 8. INSPECT NO. 1 SYNCHRONIZER RING SET (FOR 1ST GEAR) |
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and 1st gear.
![]() |
Coat the 1st gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the 1st gear cone. Check that the ring locks.
| 9. INSPECT NO. 1 SYNCHRONIZER RING SET (FOR 2ND GEAR) |
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and 2nd gear.
![]() |
Coat the 2nd gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the 2nd gear cone. Check that the ring locks.