Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR


    A158663
  1. Install the 2 air fuel ratio sensors to the exhaust manifold by the hand.



  1. Using SST, tighten the 2 air fuel ratio sensors.


    A192320E01

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.



  1. Connect the 2 air fuel ratio sensor connectors and 4 clamps.


    A192318E01



2. INSPECT FOR EXHAUST GAS LEAK