Home › ENGINE ยท 2TR-FE › STARTING › STARTER

STARTER > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CLUTCH SUB-ASSEMBLY


A062427E03
  1. Apply grease to the steel ball and install it onto the starter drive housing.

  1. Apply grease to the magnet switch return spring and install it onto the starter drive housing.

  1. Apply grease to the starter clutch, and install it onto the starter drive housing.

  1. Apply grease to the starter idle gear clutch roller and install it onto the starter idle gear retainer.

  1. Apply grease to the starter idle gear retainer and install it onto the starter idle gear pinion.

  1. Apply grease to the starter idle gear pinion and install it onto the starter drive housing.



    A074097E01
  1. Install the starter drive housing with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }



2. INSTALL STARTER ARMATURE ASSEMBLY
  1. Apply grease to the bearings and install it onto the starter yoke.



3. INSTALL STARTER BRUSH HOLDER ASSEMBLY


A062429E01
  1. Place the brush holder assembly on the starter yoke.

  1. Using a screwdriver, install the 4 brushes.

  1. Install a new O-ring onto the groove of the field frame.



    A062428E01
  1. Install the end frame with the 2 screws.



4. INSTALL STARTER YOKE ASSEMBLY


A076121E01
  1. Install a new O-ring onto the groove of the starter yoke.

  1. Align the key of the starter yoke with the groove of the magnet starter switch.



    A074096E02
  1. Tighten the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }