Home › ENGINE · 2TR-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION SWITCH


G036134E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard:
      Switch Condition
      Tester Connection
      Specified Condition
      LOCK
      -
      10 kΩor higher
      ACC
      1 (AM1) -3 (ACC)
      Below 1Ω
      ON
      1 (AM1) -3 (ACC) -4 (IG1) 7 (IG2) -8 (AM2)
      Below 1Ω
      START
      1 (AM1) -2 (ST1) -4 (IG1) 6 (ST2) -7 (IG2) -8 (AM2)
      Below 1Ω

      If the result is not as specified, replace the ignition switch.