Home › ENGINE · 1GR-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION SWITCH


G036134E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard:
      Switch Condition
      Switch Condition
      Specified Condition
      LOCK
      -
      10 kΩ or higher
      ACC
      1 (AM1)-3 (ACC)
      Below 1 Ω
      ON
      1 (AM1) - 3 (ACC) - 4 (IG1)
      7 (IG2) - 8 (AM2)
      Below 1 Ω
      START
      1 (AM1) - 2 (ST1) - 4 (IG1)
      6 (ST2) - 7 (IG2) - 8 (AM2)
      Below 1 Ω

      If the result is not as specified, replace the ignition switch.