STARTER (for 4WD) > INSPECTION |
| 1. INSPECT STARTER ARMATURE ASSEMBLY |
![]() |
Check the commutator for an open circuit.
Using an ohmmeter, measure the resistance between the segments of the commutator.
![]() |
Check the commutator for ground.
Using an ohmmeter, measure the resistance between the commutator and armature coil core.
Check whether the commutator surface is dirty or burnt.
If necessary, clean it with sandpaper (No. 400) or a lathe.
![]() |
Check the commutator for runout.
Place the commutator on V-blocks.
Using a dial gauge, measure the runout.
![]() |
Using vernier calipers, measure the commutator diameter.
![]() |
Check that the undercut portion between the segments is free of foreign objects. Measure its depth.
| 2. INSPECT STARTER YOKE ASSEMBLY |
![]() |
Check the starter yoke for an open circuit.
Using an ohmmeter, measure the resistance between the lead wire and brushes.
![]() |
Check the shunt coil for an open circuit.
Using an ohmmeter, measure the resistance between shunt coil terminals A and B.
| 3. INSPECT BRUSH |
![]() |
Check the brush length.
Using vernier calipers, measure the brush length.
| 4. INSPECT STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Check the blush holder insulation.
Using an ohmmeter, measure the resistance between the positive (+) and negative (-) brush holders.
![]() |
Check the brush spring load.
Take the pull scale reading as soon as the brush spring separates from the brush.
| 5. INSPECT STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Check the clutch pinion gear.
Hold the starter clutch, rotate the pinion gear clockwise and check that it turns freely.
Try to rotate the pinion gear counterclockwise and check that it locks.
If necessary, replace the starter clutch.
| 6. INSPECT MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Check the pull-in coil for an open circuit.
Using an ohmmeter, measure the resistance between terminals 50 and C.
![]() |
Check the holding coil for an open circuit.
Using an ohmmeter, measure the resistance between terminal 50 and the switch body.