POWER STEERING LINK (for 4WD and Pre-Runner) > INSPECTION |
| 1. INSPECT TIE ROD END SUB-ASSEMBLY |
![]() |
Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.
Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and check the torque reading on the 5th turn.
| 2. INSPECT POWER STEERING RACK |
![]() |
Using a dial indicator, check the power steering rack for runout, teeth wear and damage.
Check the back surface for wear and damage.
If necessary, replace the power steering link assembly.