Home › ENGINE ยท 2TR-FE › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Place the drive end frame on the generator rotor assembly.

    NOTICE:
    Do not drop the generator rotor assembly.

  1. Install the generator rotor assembly and plate retainer.



    G037881E01
  1. Using a 17 mm socket wrench and press, slowly press in the rectifier end frame.



    G037885E01
  1. Install the 4 nuts.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }

  1. Install the 3 terminal insulators to the rectifier end frame.



2. INSTALL GENERATOR HOLDER WITH RECTIFIER


G037884E01
  1. Install the generator holder with rectifier with the 3 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 17 in.*lbf }



3. INSTALL GENERATOR REGULATOR ASSEMBLY


G037883E01
  1. Install the generator regulator with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 17 in.*lbf }



4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


G037888E02
  1. Install the plate seal.

  1. Install the generator brush holder with the 3 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 17 in.*lbf }

  1. Install the brush cover on the generator brush holder assembly.

  1. Install the rear end cover with the 2 nuts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf }

  1. Install the rectifier plate with the nut and screw.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf } for nut

    Torque:
    3.9 N*m{ 40 kgf*cm , 34 in.*lbf } for screw

  1. Install the terminal insulator with the nut.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }



5. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Install the pulley by hand.



    A126778E01
  1. Install SST to the pulley and vise as shown in the illustration.

    SST
    09820-63021   (09821-63011)



    A126782E01
  1. Turn SST (B) counterclockwise to tighten the pulley.

    Torque:
    111 N*m{ 1127 kgf*cm , 81 ft.*lbf }

  1. Install a new cap to the pulley.

  1. Check that the generator pulley rotates smoothly.