Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR

GENERATOR > INSTALLATION

for Preparation Click here



1. INSTALL GENERATOR ASSEMBLY
  1. Install the generator assembly with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. Install the wire harness clamp bracket with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the wire harness.

    1. Connect the wire harness to terminal B and install the nut.

      Torque:
      9.8 N*m{ 100 kgf*cm , 7.0 ft.*lbf }

    2. Connect the connector to the generator assembly.

    3. Install the wire harness stay with the bolt.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



2. INSTALL FAN SHROUD


G036144E01
  1. Provisionally install the fan shroud together with the fan pulley.

  1. Install the fan and generator V belt .

  1. Install the fan pulley with the 4 nuts.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

  1. Install the fan shroud with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 48 in.*lbf }

  1. Install the 2 cooler hoses into the clamp (with automatic transmission).

  1. Connect the hose to the radiator reserve tank.



3. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH


4. INSTALL V-BANK COVER
  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



5. CONNECT CABLE TO NEGATIVE TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }