Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A075664E03
SST
09820-63011   (09820-06010, 09820-06021)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06021

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.



    A075665E02
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.



    A075666E02
  1. To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.



    A075667E03
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.



2. REMOVE REAR GENERATOR END COVER


A075668E01
  1. Place the generator on the pulley.

  1. Remove the 3 nuts, then remove the rear end cover.



3. REMOVE TERMINAL INSULATOR


A081146E01


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


A081147E01
  1. Remove the plate seal.

  1. Remove the 2 nuts, then remove the brush holder.

  1. Remove the plate seal.



5. REMOVE GENERATOR COIL ASSEMBLY


A081148E01
  1. Remove the 4 bolts.



    A081663E03
  1. Using SST, remove the coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



6. REMOVE GENERATOR ROTOR ASSEMBLY


A081664E03
  1. Remove the generator washer and the generator rotor.



7. REMOVE GENERATOR DRIVE END FRAME BEARING


A075681E01
  1. Check the bearing whether it is rough or worn. If necessary, replace the bearing.



    A075682E01
  1. Remove the 4 screws, then remove the retainer plate.



    A075683E01
  1. Using SST, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)