Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY

PERSONAL LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


    E076078E07
  1. Apply battery voltage to the connector and check the map light comes on.
    Text in Illustration 
    *a
    Component without harness connected
    (Map Light Assembly)

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    All switch off
    All light not comes on
    Battery positive (+) → 1
    Battery negative (-) → 2
    LH side switch on
    LH side light comes on
    Battery positive (+) → 1
    Battery negative (-) → 2
    RH side switch on
    RH side light comes on
    Battery positive (+) → 1
    Battery negative (-) → 2
    LH side switch on
    RH side switch on
    All light comes on

    If the light does not come on, replace the map light bulb or map light assembly.