Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


G037915E01
  1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.



    G037914E03
  1. Install the camshaft position sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or jammed when installing.



    G037913E01
  1. Connect the crankshaft position sensor connector and the 2 wire harness clamps.



2. INSTALL IDLE PULLEY ASSEMBLY WITH BRACKET (W/ AIR CONDITIONING)


G037912E03
  1. Using several steps, uniformly install and tighten the 5 bolts in the sequence shown in the illustration.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf } for bolt A
    43 N*m{ 438 kgf*cm , 32 ft.*lbf } for bolt B, C



3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING)


G038234E01
  1. Install the compressor and magnetic clutch with the 4 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

  1. Connect the compressor and magnetic clutch connector.



    G038205E01
  1. Install the bolt shown in the illustration.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



4. INSTALL FAN & GENERATOR V BELT (W/ AIR CONDITIONING)


G038204E01
  1. Provisionally install the V belt onto each pulley.

    NOTICE:
    Install the V belt onto each pulley and finally install the V belt onto the V-ribbed belt tensioner.

  1. Turn the hexagonal bolt on the V-ribbed belt tensioner clockwise and install the V belt onto the V-ribbed belt tensioner pulley.



5. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner)


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }