Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner)


3. REMOVE FAN & GENERATOR V BELT (W/ AIR CONDITIONING)


G038203E01
  1. Turning the hexagonal bolt on the V-ribbed belt tensioner clockwise, loosen and then remove the V belt.



4. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING)


G038205E01
  1. Remove the bolt shown in the illustration.



    G038234E01
  1. Disconnect the compressor and magnetic clutch connector.

  1. Remove the 4 bolts, then separate the compressor and magnetic clutch.

    HINT:
    Do not disconnect the hose. Hang the vane pump with a rope.



5. REMOVE IDLE PULLEY ASSEMBLY WITH BRACKET (W/ AIR CONDITIONING)


G037912E02
  1. Remove the 5 bolts, then remove the idle pulley with bracket.



6. REMOVE CRANKSHAFT POSITION SENSOR


G037913E01
  1. Disconnect the crankshaft position sensor connector and the 2 wire harness clamps.



    G037914E02
  1. Remove the bolt, then remove the crankshaft position sensor.