Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FAN & GENERATOR V BELT


A095340E01
  1. Visually check the belt for excessive wear, frayed cords, etc..

    1. If any defects are found, replace the V-ribbed belt.
    2. Cracks on the rib side of the belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.



    A097753E02
  1. Check that the tensioner indicator mark is within range A shown in the illustration. If the mark is not within range A, replace the V belt.