Home › ENGINE ยท 1GR-FE › LUBRICATION › OIL FILTER

OIL FILTER > INSTALLATION

for Preparation Click here



1. INSTALL OIL FILTER SUB-ASSEMBLY


A076324E01
  1. Clean the oil filter contact surface on the oil filter bracket.

  1. Apply clean engine oil to the rubber gasket of a new oil filter.

  1. Tighten the oil filter by hand until the rubber gasket comes into contact with the seat of the filter bracket.



    A076325E05
  1. Using SST, tighten it an additional 3/4 turn to set the filter.
    Text in Illustration 
    *a
    3/4 Turn

    SST
    09228-07501  

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



2. ADD ENGINE OIL
  1. Fill with fresh engine oil.

    Standard engine oil:

    Oil grade
    Oil viscosity (SAE)
    ILSAC multigrade engine oil
    5W-30


    Standard capacity (for 2WD):

    Item
    Specified Condition
    Drain and refill with oil filter change
    4.5 liters (4.8 US qts, 4.0 lmp. qts)
    Drain and refill without oil filter change
    4.2 liters (4.4 US qts, 3.7 lmp. qts)
    Dry fill
    5.6 liters (5.9 US qts, 4.9 lmp. qts)


    Standard capacity (for PRE RUNNER and 4WD):

    Item
    Specified Condition
    Drain and refill with oil filter change
    5.2 liters (5.5 US qts, 4.6 lmp. qts)
    Drain and refill without oil filter change
    4.9 liters (5.2 US qts, 4.3 lmp. qts)
    Dry fill
    6.0 liters (6.3 US qts, 5.3 lmp. qts)

  1. Reinstall the oil filler cap.



3. CHECK FOR ENGINE OIL LEAKAGE


4. CHECK ENGINE OIL LEVEL