Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > INSPECTION

for Preparation Click here



1. INSPECT CYLINDER HEAD SET BOLT


G035889E02
  1. Using vernier calipers, measure the minimum diameter of the elongated thread at the measuring point.

    Standard outside diameter:
    10.76 to 10.97 mm (0.4236 to 0.4319 in.)

    Minimum outside diameter:
    10.40 mm (0.4094 in.)

    HINT:
    If a visual check reveals no excessively thin areas, check the center of the bolt (see illustration) and find the area that has the smallest diameter.