Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


Z017274E15
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Resistance:
      Tester Connection
      Specified Condition
      1 (E2) - 2 (THW)
      2.32 to 2.59 kΩ at 20°C (68°F)
      1 (E2) - 2 (THW)
      0.310 to 0.326 kΩ at 80°C (176°F)

      NOTICE:
      If checking the engine coolant temperature sensor in water, be careful not to allow water to enter the terminals. After checking, wipe the water off the engine coolant temperature sensor.

      If the result is not as specified, replace the engine coolant temperature sensor.