Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here


HINT:
Inspect the connectors from the back side.


CHECK TIRE PRESSURE WARNING ECU

E129452E24

  1. Disconnect the T16 tire pressure warning antenna and receiver connector.

  2. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T14-12 (RDA) - T14-9 (GND)
    L-W - W-B
    Tire pressure warning antenna and receiver signal
    Ignition switch ON
    11 to 14 V

  3. Connect the T16 tire pressure warning antenna and receiver connector.

  4. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T14-1 (CLSW) - T14-9 (GND)
    G - W-B
    Tire pressure warning reset switch
    Ignition switch ON
    Tire pressure warning reset switch OFF
    11 to 14 V
    Ignition switch ON
    Tire pressure warning reset switch ON
    Below 1.5 V
    T14-2 (SPD) - T14-9 (GND)
    V-W - W-B
    Vehicle speed signal
    While being driven at approximately 20 km/h (12 mph)
    Pulse generation
    (see waveform 1)
    T14-3 (TC) - T14-9 (GND)
    G - W-B
    TC terminal
    When terminal TC is not connected
    11 to 14 V
    T14-4 (TACH) - T14-9 (GND)
    B-W - W-B
    Engine speed signal
    Idling
    Pulse generation (see waveform 2)
    T14-5 (IND) - T14-9 (GND)
    L - W-B
    Tire pressure warning light output signal
    After ignition switch is turned ON, when tire pressure warning light illuminates for 3 seconds
    0.9 to 3.2 V
    Ignition switch ON
    Tire pressure warning light off
    3.2 V or higher
    T14-6 (RF5V) - T14-9 (GND)
    R-W - W-B
    Tire pressure warning antenna and receiver power source
    Ignition switch ON
    4.5 to 5.5 V
    T14-7 (IG) - T14-9 (GND)
    LG - W-B
    IG power source
    Ignition switch ON
    11 to 14 V
    T14-9 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    T14-10 (SIL) - T14-9 (GND)
    W - W-B
    Techstream communication line
    Ignition switch ON, when communication is not performed with the Techstream
    11 to 14 V
    T14-11 (GND2) - T14-9 (GND)
    GR - W-B
    Tire pressure warning antenna and receiver ground
    Always
    Below 1 Ω



  5. F047507E05
  6. Using an oscilloscope, check waveform 1.
    Item
    Contents
    Terminal No. (Symbol)
    T14-2 (SPD) - T14-9 (GND)
    Tool Setting
    5 V/DIV., 200 ms/DIV.
    Vehicle Condition
    While being driven at approximately 20 km/h (12 mph).

    HINT:
    The wavelength becomes shorter as the vehicle speed increases.



  7. F047507E05
  8. Using an oscilloscope, check waveform 2.
    Item
    Contents
    Terminal No. (Symbol)
    T14-4 (TACH) - T14-9 (GND)
    Tool Setting
    5 V/DIV., 10 ms/DIV.
    Vehicle Condition
    Idling

    HINT:
    The wavelength becomes shorter as the engine speed increases.