NAVIGATION SYSTEM > AVC-LAN Circuit |

| 1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY |
Disconnect the R16 and R20 radio and display receiver assembly connectors.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R20-9 (AVC+) - R20-10 (AVC-) | Always | 60 to 80 Ω |
| R16-5 (TX2+) - R16-15 (TX2-) | Always | 60 to 80 Ω |
| *a | Component without harness connected (Radio and Display Receiver Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT) |
Disconnect the R20 and R16 radio and display receiver assembly connectors.
Disconnect the E15 extension module connector.
Disconnect the S23 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R20-9 (AVC+) - E15-2 (AVC+) | Always | Below 1 Ω |
| R20-10 (AVC-) - E15-3 (AVC-) | Always | Below 1 Ω |
| R16-5 (TX2+) - S23-8 (TX+) | Always | Below 1 Ω |
| R16-15 (TX2-) - S23-7 (TX-) | Always | Below 1 Ω |
| R20-9 (AVC+) - Body ground | Always | 10 kΩ or higher |
| R20-10 (AVC-) - Body ground | Always | 10 kΩ or higher |
| R16-5 (TX2+) - Body ground | Always | 10 kΩ or higher |
| R16-15 (TX2-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT MALFUNCTIONING PARTS |
Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.
|
| ||||
| OK | ||
| ||