Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

The DLC3 circuit enables reading of Diagnostic Trouble Codes (DTCs) with no Techstream by connecting terminals TC and CG of the DLC3 connector.
Stored DTCs are displayed in blinking patterns of the CRUISE MAIN indicator light located on the combination meter.

WIRING DIAGRAM


E170568E02

HINT:
When a particular warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)


    E170569E01
  1. Disconnect the E14 or E7 connector of the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-13 (TC) - E14-28 (TC)*1
    Always
    Below 1 Ω
    D4-13 (TC) - E7-17 (TC)*2
    Always
    Below 1 Ω

    1. *1: for 1GR-FE
    2. *2: for 2TR-FE

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (TC of DLC3 - BODY GROUND)


    C126742E78
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    TC (D4-13) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    C126742E79
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    CG (D4-4) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM