VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) > CALIBRATION |
| DESCRIPTION |
After replacing the VSC relevant components or performing "Front wheel alignment adjustment", clearing and reading the sensor calibration data are necessary.
Follow the chart to perform calibration.
| Replacing Parts | Necessary Operations |
| Skid Control ECU (Master Cylinder Solenoid) | Yaw rate sensor and deceleration sensor zero point calibration. |
| Yaw Rate and Deceleration Sensor |
|
| Front Wheel Alignment |
|
| CLEAR ZERO POINT CALIBRATION (for Using Techstream) |
Connect Techstream to the DLC3.
Turn the ignition switch to ON.
Operate Techstream to erase the DTCs.
Perform zero point calibration of the yaw rate and deceleration sensor using Techstream.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR AND DECELERATION SENSOR (for Using Techstream) |
Procedures for test mode.
Turn the ignition switch to off.
Check that the steering wheel is in the straight-ahead position.
Automatic transmission: Check that the shift lever in P and apply the parking brake.
Manual transmission: Check that the shift lever is in neutral and apply the parking brake.
Connect Techstream to the DLC3.
Turn the ignition switch to ON.
Switch the ECU to test mode using Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Signal Check.
Keep the vehicle stationary on a level surface for 5 seconds or more.
Check that the slip indicator light comes on for several seconds and then blinks in the test mode pattern (0.125 seconds on and 0.125 seconds off).
Turn the ignition switch to off.
| CLEAR ZERO POINT CALIBRATION (for Using SST Check Wire) |
Turn the ignition switch to ON.
![]() |
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
| *a | Front view of DLC3 |
Check that the slip indicator light comes on.
Perform zero point calibration of the yaw rate and deceleration sensor using a check wire.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR AND DECELERATION SENSOR (for Using SST Check Wire) |
Procedures for test mode:
Turn the ignition switch to off.
Check that the steering wheel is in the straight- ahead position.
Automatic transmission: Check that the shift lever in P and apply the parking brake.
Manual transmission: Check that the shift lever is in neutral and apply the parking brake.
![]() |
Using SST, connect terminals TS and CG of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON.
Keep the vehicle stationary on a level surface for 5 seconds or more.
Check that the slip indicator light comes on for several seconds and then blinks in the test mode pattern (0.125 seconds on and 0.125 seconds off).
Turn the ignition switch off.