VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) > CHECK FOR INTERMITTENT PROBLEMS |
| DESCRIPTION |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
Select areas where momentary interruptions should be monitored.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Speed Open | Front speed sensor RH open circuit detection/ Error or Normal | Normal | - |
| FL Speed Open | Front speed sensor LH open circuit detection/ Error or Normal | Normal | - |
| RR Speed Open | Rear speed sensor RH open circuit detection/ Error or Normal | Normal | - |
| RL Speed Open | Rear speed sensor LH open circuit detection/ Error or Normal | Normal | - |
| EFI Communication Open | ECM communication open circuit detection/ Error or Normal | Normal | - |
| Yaw Rate Open | Yaw rate and acceleration sensor open circuit detection/ Error or Normal | Normal | - |
| Deceleration Open | Deceleration sensor open circuit detection/ Error or Normal | Normal | - |
| Steering Open | Steering angle sensor open circuit detection/ Error or Normal | Normal | - |
| Master Cylinder Open | Master cylinder pressure sensor open circuit detection/ Error or Normal | Normal | - |
| IG Voltage Value Decreased | IG1 voltage value decreased detection/ Error or Normal | Normal | - |
| IG Voltage Value Increased | IG1 voltage value increased detection/ Error or Normal | Normal | - |
| FR Speed Sensor Voltage Open | Front speed sensor RH voltage open circuit detection/ Error or Normal | Normal | - |
| FL Speed Sensor Voltage Open | Front speed sensor LH voltage open circuit detection/ Error or Normal | Normal | - |
| RR Speed Sensor Voltage Open | Rear speed sensor RH voltage open circuit detection/ Error or Normal | Normal | - |
| RL Speed Sensor Voltage Open | Rear speed sensor LH voltage open circuit detection/ Error or Normal | Normal | - |
| M/C Pressure Sensor Noise | Master cylinder pressure sensor noise detection/ Error or Normal | Normal | - |
| Yaw Rate Sensor Voltage Open | Yaw rate and acceleration sensor voltage open circuit detection/ Error or Normal | Normal | - |
| EFI Communication Invalid | ECM communication invalid detection/ Error or Normal | Normal | - |
While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors or between ECUs.